Garage Door Spring Repair
Torsion and extension spring replacement with a full balance check afterward.
Springs do the heavy lifting on a garage door. A typical two-car steel door weighs well over a hundred pounds, and the springs hold almost all of that so the opener only has to nudge it. When a spring breaks, that weight is suddenly back on the cables and the motor.
Most broken springs announce themselves with a bang from the garage, often on a cool morning. Afterward the door may lift a few inches and stop, or the opener strains and quits. Look above the door: a torsion spring with a two-inch gap in the coil is broken. Do not try to wind or release it yourself; the stored energy can cause serious injury.
How we replace a spring
- We clamp the door so it cannot move, then unwind the remaining tension with proper winding bars.
- The door is weighed and measured so the new spring matches its weight, height and track radius.
- On two-spring doors we replace both, since the second spring is close to the end of its life.
- We wind to the correct turns, lubricate, and test that the door stays put halfway up.
Torsion or extension?
Torsion springs
Mounted on a steel shaft above the door. They wind up as the door closes and are the standard on most newer Destin homes.
Extension springs
Stretch along the horizontal tracks on each side. They must run with safety cables through the coils, which we add if they are missing.
Coastal rust shortens spring life
Salt air pits the spring wire, and a pitted coil fails sooner than its cycle rating suggests. We offer galvanized or coated springs on Gulf-front and bayside homes and wipe them down with a light lubricant after installation.



Garage Door Spring Repair: where the price starts
- Spring replacement per spring
- From $150
- Diagnostic visit $0 when you approve the repair
- $0
Entry price for a standard residential door. Door weight, hardware grade and extra worn parts can change it; you get the exact figure on site before any work begins.