Garage Door Opener Repair
Motors, sensors, remotes and logic boards, tested together with the door they drive.
An opener is a small motor with a lot of safety rules attached. When it acts up, the cause is just as often the door it drives: a weak spring or a binding roller makes the opener sense resistance and stop. We check both before we sell you a part.
First the door comes off the opener and gets a hand test. If it moves freely, we focus on the unit: the photo-eye sensors near the floor, the wall button, the remote and keypad, the drive gear or belt, and the circuit board. Many faults turn out to be a sensor knocked out of line or a stripped plastic gear, both simple fixes.
Opener problems we repair
- Door closes, touches the floor and goes back up
- Lights blink and the door will not close at all
- Motor hums but the chain or belt does not move
- Remote works from the driveway only, not from the street
- Opener runs on its own or ignores the wall button
- Grinding noise from the motor head
Sensors and the reverse test
Federal safety rules for openers built after 1993 require them to reverse when they hit an obstruction and to stop for the photo eyes. After any repair we lay a board flat in the door's path and close the door on it. It must reverse. We also wave a box through the beam to confirm the eyes stop the door.
Humidity and electronics
Damp garages near the bay can corrode sensor wiring and remote batteries faster than you would expect. We check connections at the sensors and the motor head on every opener call and replace brittle wire rather than taping it.



Garage Door Opener Repair: where the price starts
- Opener repair priced after testing the unit
- On-site quote
- Diagnostic visit $0 when you approve the repair
- $0
Entry price for a standard residential door. Door weight, hardware grade and extra worn parts can change it; you get the exact figure on site before any work begins.